Everything you need across all four modules. Items marked Provided are supplied or shared by Rysera on the day. Items marked Own should be sourced before the relevant session.
128×64 monochrome display — shows menus, time, and sensor data
Own
PCB Design9 items
Copper Clad Board (A4)×1
Base material for the home-etched Medibox PCB
Provided
Ferric Chloride (FeCl₃)shared
Chemical etchant to remove unwanted copper
Provided
PCB Drill Setshared
For drilling component through-holes
Provided
Vero Board (Brown)×1
Fallback stripboard for practice layouts
Provided
2-pin JST Connector×1
Power input connector footprint for the Medibox PCB
Provided
Small-tip Permanent Marker×1
Toner-resist method for resist-drawing PCB tracks
Provided
Safety Goggles×1 pair
Eye protection during FeCl₃ etching
Provided
Latex Chemical Gloves×1 pair
Hand protection during etching
Provided
Soldering Iron + Solder Wireshared
For soldering components onto the finished PCB
Provided
3D Design3 items
TinkerCAD (Browser-based)—tinkercad.com
Free CAD tool used to design the Medibox enclosure — no install required
Provided
3D Printer + PLA Filamentlab
Enclosure is printed at the Rysera lab from your exported STL file
Provided
Plastic Container×1
Assembly housing for the completed Medibox device
Own
Shared / General2 items
Laptop or Desktop Computer×1
Required for Arduino IDE, KiCad, and TinkerCAD throughout all sessions
Own
USB-A to Micro-USB Cable×1
For flashing firmware to the ESP32 Dev Board
Own
Component specifications are subject to minor revision before each session. Your instructor will confirm any changes on the session day. All shared/lab items are available at the workshop venue — you do not need to bring them.